How to install a toilet paper dispenser in a home bathroom? - bathroom dispensers
We have recently renovated the bathroom and try to accessories in What is the best way to set the extent to which media measurement for the toilet paper holder?
Monday, December 28, 2009
Bathroom Dispensers How To Install A Toilet Paper Dispenser In A Home Bathroom?
Subscribe to:
Post Comments (Atom)
1 comments:
I assume from your question that the brackets are two rooms instead of a body. The container with the media on both sides of the supporting role. To place a table of May with the owner of the spring roll to make it) not in holes in the fall and supports a roll of paper in it (or just a cardboard tube together to ensure the separation of media. If you do this alone, the position of a couple of thick books and adapt to the way you want (not) too tight or too loose. Use a tape measure, measure the distance between the center of each screw) hole at the rear of the dealer (center to center. It is a measure of its distance. With a level, mark the wall where you (place the screws a zero, a further measure of the distance from zero). I sat on the toilet while you maintain, then the position of the dealers are too high or too low - perhaps 2 feet above the ground? If one of your media on one ofStud, drill a pilot hole before the screws on the wall - most likely hold the screw directly on the wall.
Good luck!
Post a Comment